|
|
|
| Home
/ Model Kits / Free Flight
Rubber Powered Airplane Kits / FF-15LC
Taylor Cub (Laser Cut)
The Taylor Cub was designed by C. Gilbert Taylor and first flow in
September 1930. It was the precursor to the Piper Cub. Kit FF-15
Taylor Cub is 1/23 scale, flying model built with the Box
and Former method. Pre-1942 design, eligible for Society of Antique
Modelers (SAM) contests.
This free flight rubber powered kit contains a full-size
rolled plan, building and flying instructions, LASER
CUT balsa parts, hand-picked balsa strip wood, rubber motor, propeller, nose package,
clear plastic for the windshield, wheels, landing gear, and Easy
Built Lite colored tissue. You will need a building
board, pins, hobby knife, fine
sandpaper, and glue.
FF-15LC Taylor Cub (LASER
CUT)
Wingspan: 18"
Class: Scale flyer
Building Skill / Flying Skill: Easy / Easy
Price: $18.95
Customer photos:
Submit
a photo of your model!
 
 
"Home
made balsa wheels, 1/32 sheeting around nose area. Landing gear bungies
are heat shrink tubing over balsa sticks. I found a picture on the
internet of an actual J-2, printed it, and mirror imaged the picture
to obtain one left and one right cylinder/stack combo. I cut those
out of the pics, glued them to 1/16" balsa sheet, then onto some
dummy balsa cylinders. Looks real. I
had to add a bit of nose weight to balance it out, but it flies very
well." -
Dave Hable
 
 
 
Balsa Model Airplane Kit, Balsa flies better. |
Site Map Home
© 1999-2010 Easy Built Models. All rights reserved.
10/06/09 01:16 AM (EDT).
|
