FREE Shipping on orders over $150! * |
Designed as a lightweight outdoor endurance plane, this model has finished in the top 5 in Old Time Rubber contests. Removable wing, similar to "Miss World's Fair". Pre-1942 design, eligible for Society of Antique Modelers (SAM) contests.
This free flight rubber powered kit contains a full-size rolled plan, hand-picked printed balsa and balsa strip wood, rubber motor, E-B propeller, EBM thrust bearing, clear plastic for the windshield, wheels, wire, and Easy Built Lite tissue in a variety of bright colors. To build this model you will need a building board, hobby knife, fine sandpaper, and glue.
Includes a hobby knife, 5 blades, straight point tweezers, 5.5" x 9" Self Healing Cutting Mat, Jet Instant glue, Jet Super glue, Jet Tips, glue stick, canopy glue/tacky glue, MagnaBoard XL™ set, Minus Magnets 20 pack, and Rubber Powered Model Airplanes book. Save 25% off individually priced items! There is a limit of 2 sets per order.
item B329 Price: $79.95Excludes the book on rubber power and the glue stick. Includes a hobby knife, 5 blades, straight point tweezers, 5.5" x 9" Self Healing Cutting Mat, Jet Instant glue, Jet Super glue, Jet Tips, canopy glue/tacky glue, MagnaBoard XL™ set, and Minus Magnets 20 pack. Save 25% off individually priced items! There is a limit of 2 sets per order.
item B332 Price: $66.95Includes Sanding Stick with 120, 240, 320, 400, and 600 grit belts, Pull Saw Blade, K5 Heavy Duty Knife with beveled blade, Narrow Keyhole Saw Blades 5 pack, Curved Tip Tweezers, 1/16" Ball Tip Burnisher, Jewelers Needle Point Awl, Steel Ruler 6" x 1" with drill gauge, 15 piece drill set (1.05mm - 2mm). Save 30% off individually priced items!
item B330 Price: $45.99Includes a 10:1 winder, moldable nose weight, FAI SuperSport rubber 32 feet each 3/32", 1/8", and 3/16" and 32 feet EBM 1/16" rubber. Save 23% off individually priced items!
item B331 Price: $34.95"Dave, a photo of the finished model is attached. I test flew it today. On its first full power flight, 1,000 turns, six strands of 1/8, it was OOS at ten minutes. Luckily, I went down the bearing and found it about a mile away. Now I'm going to put a DT on it! " - Grant Carson
"These are the pictures of the Scatterbrain, it was a lot of fun to build and very different looking. I now have it almost trimmed out. It is super stable and if it hits turbulence it really corrects itself super fast. I am flying it with 6 strands of 1/8, 17" long." - Mike Breen